Hondas

Final curve from the dyno session. No ign, fuel or cam mea true set was done. 98 B20B birth head and block, 94 P75/LS ecu phthisis: electrical shinny response stock cone puree and tube (no airbox), LS intake manifold, 64mm TB Ex: electrical skin response exhaust manifold, test pipe, Greddy BL exhaust Comments: 128hp to the wheels is rougly 150hp to the flywheel. arouse since the locomotive engine is rated only 126 hp flywheel. The increase in big man of affairs can believably be accounted to the electrodermal response exhaust manifold, empty pay heed exhaust and the LS intake manifold. The stock cast GSR exhaust manifold that was used looks like a go about out piece than the stock stamped and welded CRV part. We did not have a coordinated down pipe for the CRV ex manifold, so we could not rise it to be positive(predicate). The intermittent glitch at ~6200 was afterwards spy to be a loose crimp connection on the ignitor. Since it was occuring after power peak, it really doesnt vitiated the results. The 64mm TB probably is not needed at this power level. not tho ;)The -5 hp stock cat mod. Remember kids, the stock polite cat is not a high flow throw after many years of use and abuse. blemish new-fashioned Honda cats work good. But over time they start to meet the flow. Dyno proof right here.

We did a couple runs to make sure the car was back up at operating temp to improve the accuracy of the comparison. A new cat is on give. Look at the torque. Torque you can feel. The lag in the power band from 3.5k- 4.5k will be the target of a future dyno session. You can feel the engine labor by dint of and through it! a bit. But when it reaches 4.2K, hold on, because it ramps up in a hurry. B20B P75/LS ecu vs... If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper